Insulating the walls of your house this winter is very appealing to Thermique, as the main benefit of doing so is saving on the energy bills and adding value to their home.

The main grant relating to home insulation which is available from the Sustainable Energy Authority of Ireland (SEAI) will be the Home Energy Saving (HES) scheme. Homeowners can take advantage of this grant if they wish to spend money on boosting the energy efficiency of the dwellings through insulating the walls of the house.

The year when the house was constructed will most likely determine the type of insulation required. When the house was built since 1920, your house will most likely have cavity walls and more than likely, in the event the house was built after 1950. Solid walls are definitely the other main construct of your home.

Cavity Walls will have two skins of brick, or one brick and one concrete block, having a gap in the middle, where air circulates and thus prevents water penetration. By insulting this gap will prevent air circulation, trapping the air and thereby stopping heat loss by approximately 65 percent.

Insulating cavity walls, however, requires every exterior wall to be treated concurrently. Therefore, it is best suited from a cost viewpoint for homes which are heated throughout long periods. This sort of insulation will not be practical for a block of apartments, unless the complete building is being insulated simultaneously.

For cavity walls, there are 2 main home insulation methods what are the dry method as well as the foam method.

The dry method utilises mineral-wool fibres or expanded polystyrene beads blown through holes drilled on the outer top of the wall until the cavity is filled and insulation is done. This process also ensures the optimum utilization of materials used.

The foam method can be produced on site and pumped with the holes burrowed on the outside wall. The foam dries after a few days and solidifies, and it should be noted for timber-framed homes.

Solid walls can be insulated in a different way, by either insulting the exterior of the walls or line the interior top of the wall. These two methods can lead for the joinery, electrical and plumbing supplies being affected.

Another downside of this method is that it is extremely expensive and may modify the visage from the building involved. This can be caused as the cladding required on the exterior wall is surely an elaborate process, affecting pipes, windows wcuiuh doors. These functions may need to be repositioned to accommodate the insulation.

By lining the interior wall, skirting boards, picture rails, architraves, lights, sockets and radiators may be affected and will have to be repositioned as a result. Utilizing a thermal board can be employed to insulate the inside wall also by fixing the boards to battens. This can be done by attaching the thermal board direct towards the walls having a board recommended adhesive, having an additional fixing of screws to hold the thermals boards in place.

Isolation Des Murs – Take A Look At This..

We are using cookies on our website

Please confirm, if you accept our tracking cookies. You can also decline the tracking, so you can continue to visit our website without any data sent to third party services.